Router-Aging-Time (Igmp Snooping View); Source-Deny (Igmp Snooping View) - HP A5120 EI Series Command Reference Manual

Default level
2: System level
Parameters
None
Description
Use the reset igmp-snooping statistics command to clear the statistics information of IGMP messages
learned through IGMP snooping.
Examples
# Clear the statistics information of all kinds of IGMP messages learned through IGMP snooping.
<Sysname> reset igmp-snooping statistics

router-aging-time (IGMP snooping view)

Syntax
router-aging-time interval
undo router-aging-time
View
IGMP snooping view
Default level
2: System level
Parameters
interval: Specifies an aging time for dynamic router ports in seconds. The value range is 1 to 1000.
Description
Use the router-aging-time command to configure the aging time for dynamic router ports globally.
Use the undo router-aging-time command to restore the default.
By default, the aging time of dynamic router ports is 105 seconds.
This command works only on IGMP snooping–enabled VLANs.
Related commands: igmp-snooping router-aging-time.
Examples
# Set the aging time for dynamic router ports to 100 seconds globally.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] router-aging-time 100

source-deny (IGMP snooping view)

Syntax
source-deny port interface-list
undo source-deny port interface-list
32