Igmp-Snooping Query-Interval; Igmp-Snooping Report Source-Ip - HP A5120 EI Series Command Reference Manual

igmp-snooping query-interval

Syntax
igmp-snooping query-interval interval
undo igmp-snooping query-interval
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an interval between IGMP general queries, in seconds. The effective range is 2 to 300.
Description
Use the igmp-snooping query-interval command to configure the interval between IGMP general queries.
Use the undo igmp-snooping query-interval command to restore the default.
By default, the IGMP general query interval is 60 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, igmp-snooping max-response-time, igmp-snooping querier,
and max-response-time.
Examples
# Enable IGMP snooping and set the interval between IGMP general queries to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20

igmp-snooping report source-ip

Syntax
igmp-snooping report source-ip { ip-address | current-interface }
undo igmp-snooping report source-ip
View
VLAN view
Default level
2: System level
Parameters
ip-address: Specifies a source address for the IGMP reports that the IGMP snooping proxy sends. The
address can be any legal IP address.
21