Installing The Drivers And Other Software In Your Pc - Epson Stylus Scan 2000 Manual

Do not use the Stylus Scan's parallel port and USB port simultaneously.
Connect the Stylus Scan to one computer at a time.
Using the parallel port (for Windows 95 or 98)
To connect the Stylus Scan to your PC using the parallel port, you need a shielded,
twisted-pair parallel cable. Follow these steps.
1. Make sure both the Stylus Scan and computer are turned off.
2. Plug the cable connector securely into the parallel interface connector at the rear
of the Stylus Scan. Then squeeze the wire clips together until they lock in place
on both sides.
3.
Plug the other end of the cable into the computer's parallel interface. If there is a
ground wire at the computer end of the cable, connect it to the ground connector
at the back of the computer.
You are now ready to install the Stylus Scan drivers. For installation instructions, see
"For Windows 95 or 98 with a parallel connection" on page 10.
Using the USB port (for Windows 98 or Macintosh)
To connect the Stylus Scan to your computer using the USB port, you must first install
the Stylus Scan drivers.
See "For Windows 98 with a USB connection" on page 13 to install the drivers and
connect the Stylus Scan to your Windows 98 computer using the USB port.
To install the software and connect the Stylus Scan to your Macintosh, see "Installing
the Software in Your Macintosh" on page 19.

Installing the Drivers and Other Software in Your PC

Your Stylus Scan comes with the EPSON Stylus Scan 2000 Software for Windows
CD-ROM which includes software for your Stylus Scan.
To print and scan with your Stylus Scan, you need to install the following software
included on the CD-ROM.
EPSON SMART PANEL
Provides easy access to the Stylus Scan's scanning, printing, and copying features.
EPSON Stylus Scan 2000 Drivers
Printer Driver
Allows you to use the Stylus Scan's printer function.
Setting Up Your Stylus Scan 2000
9