Epson Stylus Scan 2000 Manual page 14

Note:
If you turn on the EPSON Stylus Scan before turning on your computer, the computer
may detect the Stylus Scan and display the New Hardware Found dialog box, or a
similar wizard, following start-up. If this occurs, click the Cancel button to close the
dialog box and remove the USB cable. Then continue with installation as described
below.
Insert the EPSON Stylus Scan 2000 Software for Windows CD-ROM in the
2.
CD-ROM drive. The Select Language dialog box appears.
Select the language you want and click OK.
3.
Click the Add Software button.
4.
The EPSON Software Setup dialog box appears. Make sure there is a check mark
5.
next to EPSON SMART PANEL and EPSON Stylus Scan 2000 Drivers. Clear the
check marks next to the names of any other software that you do not want to install.
Click OK.
6.
14
Setting Up Your Stylus Scan 2000