General Features; Sending Commands; Receiving Commands; Active Lock/Arm And Unlock/Disarm - Firstech 2WT11R-SS User Manual

General Features

The remote transmitter functions are predetermined and programmed from the factory. The five button
configuration allows for many functions to be performed through a series of tapping and/or holding
buttons.

Sending Commands

When in range and a command has been sent, the remote pager backlight will illuminate, the remote will
beep and the appropriate icon will be displayed. For example, to send a remote start command from the
pager, hold the Key/Start button for 2.5 seconds. The backlight will illuminate and the remote will
beep and the text "Remote Start" will flash on the screen, confirming that the command has been sent
and the remote is in range. Once the vehicle has successfully remote started, the remote will receive a
confirmation indicating the vehicle is running.

Receiving Commands

The remote pager will receive commands indicating the status of the vehicle, confirmation of sending
commands and alarm notifications. For example, after pressing the lock button, the lock icon will update
confirming the vehicle has been successfully locked/armed. To see if your pager is in range, tap the
button for a half second – if the pager backlight illuminates and beeps, the pager is in
Key/Start
range. The temperature in the vehicle will also display.

Active Lock/Arm and Unlock/Disarm

Tap the Lock button for a half second to lock/arm your vehicle. Tap the Unlock button
to unlock/disarm your vehicle. If equipped, this will also activate your starter kill and anti grind
feature. You will not be able to start your vehicle with the key until unlock/disarm.
IMPORTANT: If your alarm has been triggered (Siren is sounding, parking lights flashing, and/or
horn honking), you must wait until your 2 Way remote has been paged before disarming. The first
unlock button tap will shut off the alarm. The second will unlock/disarm the system.

Passive Lock/Arm

The system can be configured to passively lock and arm the vehicle. Put the system in
passive by tapping the Function button three times and then tapping the Unlock
button. "PASSIVE ARMING ON" will flash across the screen and Passive icon will illuminate
indicating that your vehicle is in passive lock and arming mode. Repeat the above procedure
to turn Passive Mode off.
While in passive mode, the system will lock and arm the alarm 30 seconds after the last door is closed.
As an indicator that the vehicle is going to passively lock and arm, the remote and siren will chirp once
and the parking lights will flash once at both 10 and 20 seconds prior to passively locking and arming. If
you want the system to passively arm and not passively lock, ask your local Firstech dealer to configure
this setting.

Automatic Transmission Remote Start Function

Hold the Key/Start button for 2.5 seconds to remote start an automatic transmission
vehicle. If you are in range and vehicle is ready to start, the remote will beep once and the
backlight will light up indicating that the remote start command has been successfully
transmitted.
If you are in range and the remote beeps three times, displays "START ERR – 01 through 10" you have
a remote start error. Refer to the "remote start error diagnostic" on the last page of this manual for
details.
11