Remote Start Error Diagnostic - Firstech 2WT11R-SS User Manual

STEP 2: Within 2 seconds after cycling the ignition for the 5
remotes or the (lock) button on 1 way remotes for a half second. The parking lights will flash once to
confirm the transmitter has been coded.

Remote Start Error Diagnostic

If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
1
2
3
4
5
6
7
8
9
10
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us
directly.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle's parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate
the shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Flashes
1
2
3
4
Exiting Programming: Programming is a timed sequence. The parking
lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in
step 2, code additional remotes by pressing button (I) on 2 way
remotes or the (lock) button on 1 way remotes. The parking lights will
flash once confirming each additional remote. All compatible systems
can recognize up to 4 remotes.
Remote Start Error
Motor running or must first program tach
Key in ignition on position
Door open (manual transmission only)
Trunk open
Foot brake on
Hood open
Reservation off (manual transmission only)
Tach or tachless sensing failure
FT-DAS sensor shutdown
System is in Valet Mode
Remote Start Shutdown Error
Lost engine sensing signal
Lost emergency brake signal
Foot brake triggered
Hood pin triggered
th
time, tap the Lock button
19
on 2 way