General System Functions - Firstech 1WAMR-Fiance User Manual

Additional
Button Duration Function / Description
Programming Required
0.5 seconds no Aux 2. Triggers the auxiliary 2 output (most commonly used for rear defrost or window roll-down)
2.5 seconds no Activates the remote start. Repeat and remote start will shut off.
0.5 seconds no Turns siren on/off (Note: With the siren off, it will still sound in the event the alarm is triggered)
0.5 seconds no Valet mode (see Valet Mode section for details)
2.5 seconds no Turns the shock sensor on/off. (Alarm or Alarm/Starter systems only)
0.5 seconds yes Drive lock. Activates ignition controlled door locks.
0.5 seconds no Activates passive arming (vehicle will arm/lock 30 seconds after the vehicle is disarmed)
Activates timer start mode. Timer start mode has multiple programmable settings:
0.5 seconds
yes
duration settings, temperature settings and self start settings.
Activates the built in Turbo timer function. Additional installation is required when using
yes
0.5 seconds
this feature on automatic transmission vehicle's.
2.5 seconds no Car Check (updates vehicle status on remote pager) / Secure Auxiliary
By Firstech, LLC 6

General System Functions

The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for many
functions to be performed through a series of tapping, holding and / or multiple presses of buttons. Although Firstech remotes have numerous
button functions and capabilities, please keep in mind that the most common functions are performed in one simple step. There are advanced
features not described in this manual. Please go to www.compustar.com for more details.
Tap button for 0.5 seconds to lock/arm and unlock/disarm. The LED will flash on your remote. If your vehicle is locked, tap
button to unlock; if your vehicle is unlocked, tap button
IMPORTANT: If the alarm has been triggered (Siren is going off), you must wait up to 5 seconds before disarming the alarm - the
first button tap will shut off the alarm and the second will unlock/disarm the system.
Press the button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range and if the vehicle is ready to remote
start, the parking lights will flash once and/or siren chirp once to indicate that the remote start command has been successfully transmitted.
If you are in range and the parking lights flash and/or vehicle's siren chirps three times, there is a remote start error. Refer to the "remote start error
diagnostic" at the end of this manual for details.
The remote start run time can be programmed for 3, 15, 25, or 45 minutes - ask your local Firstech dealer to adjust Option 2-7 if you
would like a run time other than 15 minutes (default).
IMPORTANT: Your vehicle's key must be inserted into the ignition and turned to the "on" position prior to driving your vehicle. If the foot brake
is depressed prior to the key being in the "on" position, the vehicle will shut off.
to lock.
7 By Firstech, LLC