Configure Wpa/Wpa2 - D-Link dap-1533 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (192.168.0.50). Click
on Setup and then click Wireless.Settings on the left side.
2. Next to Security Mode section, select Enable.WPA.Wireless.
Security.(enhanced) from the drop-down menu.
3. Next to Cipher Type, select TKIP, AES, or Auto.(TKIP/AES).
4. Next to PSK/EAP, select either PSK or EAP.
5. Next to Network Key, enter a key. The key is entered as a passphrase
in ASCII format at both ends of the wireless connection. The
passphrase must be between 8-63 characters.
6. Click Save.Settings at the top of the window to save your settings.
If you are configuring the access point with a wireless adapter, you
will lose connectivity until you enable WPA-PSK on your adapter
and enter the same passphrase as you did on the access point.
D-Link DAP-1533 User Manual

Configure WPA/WPA2

66