Configure Wpa/Wpa2 Personal - D-Link DAP-1260L User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (dlinkap.local). Click
on Setup and then click Wireless.Setup on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto(WPA.or.WPA2),.WPA2.only,.or
WPA.only.
4. Next to Cipher Type, select TKIP, AES, or TKIP.and.AES.
5. Next to Pre-Shared Key, enter a key. The key is entered as a
passphrase in ASCII format at both ends of the wireless connection.
The passphrase must be between 8-63 characters.
6. Click Save.Settings at the top of the window to save your settings. If you are configuring the access point with a wireless
adapter, you will lose connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on
the access point.
D-Link DAP-1260L User Manual

Configure WPA/WPA2 Personal

67