Table of Contents
Advertisement
Part No. 93–4690
1. Height-of-cut range, front
Part No. 100–6553
1. Remove key and read
Operator's Manual before
performing maintenance
2. Thrown objects–Keep
bystanders away
Part No. 93–7818
1. Danger– Read and understand Operator's Manual for
information on blade torque.
Assembly
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Drive Shaft
Capscrew
Locknut
Roll Pin
Decals
Parts Catalog
Operator's Manual
CE Certificate
Registration Card
3. Rotating blades can cut
hands and feet
4. Keep deflector in place
Qty.
Specifications
Type: 71-5/8 in. (1.82 m) width of cut, 3 blades.
Height Of Cut: 1 to 4-1/2 in. (25 to 114 mm) adjustable
in 1/2 in. (13 mm) increments. Front adjustment is with
snapper pin and grooves in castor shaft. Rear adjustment
is with hanger brackets and pin.
Construction: Housing is 12 gauge steel.
Cutter Drive: PTO driven gear box transmits power
through a "BB" section hex. belt to all blade spindles.
Blades: Three 24.75 in. (55 mm) long, .25 in. thick,
heat-treated steel.
Suspension & Castor Wheels: Two front castors,
consisting of 10 in. (254 mm) pneumatic wheel and tire
assembly with sealed ball bearings. Rear of deck is
suspended from lift arms with adjustable deck rake.
Hydraulic counter balance and lift system designed
integral with deck for maximum flotation.
Anti–scalp Features: Anti-scalp cup located on each
blade. Skid on left end of deck. Two adjustable gage
wheels on front of deck. Four adjustable gage wheels on
rear of deck.
Deck Covers: 14 gauge steel covers.
Quick Attach System: Tapered joint with over center
adjustable tensioning latch.
Weight: Approximately 500 lb.
Specifications and design subject to change without
notice.
Use
1
2
Mount drive shaft to cutting unit.
2
1
Apply over decal, part no. 100–6582, for ANSI
2
complicance (2 places).
1
1
Read before operating machine.
1
1
Fill out and return to Toro.
6
Advertisement
Table of Contents
