Safety; Before Operating; While Operating - Toro 30373 Operator's Manual

Safety

Hazard control and accident prevention are dependent
upon the awareness, concern, and proper training of
the personnel involved in the operation, transport,
maintenance, and storage of the machine. Improper
use or maintenance of the machine can result in injury
or death. To reduce the potential for injury or death,
comply with the following safety instructions.

Before Operating

1. Read and understand the contents of this Operator's
Manual before operating the machine. Become
familiar with all controls and know how to stop
quickly. A free replacement manual is available by
sending complete Model and Serial Number to:
The Toro Company
8111 Lyndale Avenue South
Minneapolis, Minnesota 55420–1196
2. Never allow children to operate the machine. Do not
allow adults to operate machine without proper
instruction. Only trained operators who have read this
manual should operate this machine.
3. Never operate the machine when under the influence
of drugs or alcohol.
4. Remove all debris or other objects that might be
picked up and thrown by the cutter blades. Keep all
bystanders away from the mowing area.
5. Keep all shields and safety devices in place. If a
shield, safety device or decal is illegible or damaged,
repair or replace it before operation is commenced.
Also tighten any loose nuts, bolts and screws to ensure
machine is in safe operating condition.
6. Do not operate machine while wearing sandals, tennis
shoes, sneakers or shorts. Also, do not wear loose
fitting clothing which could get caught in moving
parts. Always wear long pants and substantial shoes.
Wearing safety glasses, safety shoes and a helmet is
advisable and required by some local ordinances and
insurance regulations.
7. Check interlock switches daily for proper operation
(Refer To Section in Traction Unit Operator's Manual
on Checking Interlock Switches). Do not rely entirely
on safety switches -shut off engine before getting off
seat. If a switch fails, replace it before operating the
machine. The interlock system is for your protection,
so do not bypass it. Replace all interlock switches
every two years. Interlock switches should be adjusted
so:
A. Engine cannot be started unless traction pedal is
released (neutral position) and PTO switch is
DISENGAGED (off position).
B. Engine stops if operator gets off seat when traction
pedal is depressed.
C. Engine stops if operator gets off seat when PTO
lever is ENGAGED (on position).
8. Fill fuel tank before starting the engine. Avoid spilling
any fuel. Since fuel is flammable, handle it carefully.
A. Use an approved fuel container.
B. Do not fill tank while engine is hot or running.
C. Do not smoke while handling gasoline.
D. Fill fuel tank outdoors and up to about one inch
from top of the tank, not the filler neck.
E. Wipe up any spilled gasoline.

While Operating

9. Do not run the engine in a confined area without
adequate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
10. Maximum seating capacity is one person. Never carry
passengers.
11. Sit on the seat when starting the engine and operating
the machine.
12. This product may exceed noise levels of 85 dB(A) at
the operator position. Ear protectors are recommended
for prolonged exposure to reduce the potential of
permanent hearing damage.
13. Before starting the engine:
A. Engage the parking brake.
B. Ensure traction pedal is in neutral and PTO is in
the OFF, disengaged position.
C. After engine is started, release parking brake and
keep foot off traction pedal. Machine must not
move. If movement is evident, the neutral return
mechanism is adjusted incorrectly; therefore, shut
engine off and adjust until machine does not move
when traction pedal is released.
14. Using the machine demands attention, and to prevent
loss of control:
A. Mow only in daylight or when there is good
artificial light.
B. Drive slowly and watch for holes or other hidden
hazards.
C. Do not drive close to a sand trap, ditch, creek or
other hazard.
3