Table of Contents
Advertisement
4
Installing the Discharge Tunnel
Plug
Parts needed for this procedure:
1
Discharge tunnel plug
Procedure
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Figure 7). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
1. Discharge door handle
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Figure 7).
Note: Ensure that the arrow on the plug decal
points upward.
3. Push the plug all the way in until the spring clip on
the bottom of the plug clicks into place, locking the
plug securely into the discharge tunnel (Figure 8).
Figure 7
2. Plug, rotated clockwise
1. Spring clip
4. Release the discharge door handle to lock the top
of the plug.
5
Filling the Crankcase with Oil
No Parts Required
Procedure
The engine crankcase is shipped without oil. You
must fill it with approximately 30 ounces (0.88 l) of oil
before starting the engine. Refer to Checking the Engine
Oil Level in Operation (page 11) for oil specifications
and instructions.
9
Figure 8
Advertisement
Table of Contents
