Table of Contents
Advertisement
3. Slide the bag support rod through the second from
the top mounting holes in the handle and secure
each end with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to the left
handle below the bag support rod.
2
Installing the Starter Rope
No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 4).
1. Starter rope
Note: To make the rope easier to install, squeeze the
control bar on the handle.
3
Installing the Fuel Tank and
the Fuel Line
Parts needed for this procedure:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Slide the end of the fuel line onto the elbow fitting
(Figure 5).
Figure 4
2. Rope guide
1
2
3
4
1. Fuel tank
2. Elbow fitting
2. Secure the fuel line in place with the fuel line clamp
(Figure 5).
3. Slide the plastic clips on the front of the fuel tank
onto the fuel tank mount (Figure 6).
1. Plastic clip (2)
4. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from the
bottom. Torque the screws to 40 to 50 in-lb (4.5
to 5.6 N⋅ ⋅ ⋅ m).
8
G002527
Figure 5
3. Fuel line
4. Fuel line clamp
Figure 6
Advertisement
Table of Contents
