Operator's Compartment - Genie GTH-1048 Service Manual

March 2015
2-1

Operator's Compartment

How to Remove the Operator's
Compartment
The operator's compartment is used to activate
machine functions while sitting in the operator's
drivers seat.
Within the operator's compartment there is a
transmission column shifter, steering selector,
4-way controller, accelerator pedal, brake pedal
and a differential lock switch. All of these
components are replaceable.
For further information or assistance, consult the
Genie Industries Service Department.
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
1 Open the access door above the hydraulic tank.
2 Disconnect the battery from the machine.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Part No. 123701
Operator's Compartment
3 Locate the secondary function manifold under
the manifold inspection cover. Tag, disconnect
and plug the hydraulic hoses at ports BP and
BT of the secondary function manifold. Cap the
fittings. See 7-3, Secondary Function Manifold
Components .
4 Locate the brake manifold under the manifold
inspection cover. Tag, disconnect and plug the
hydraulic hose at the underside of the brake
manifold. Cap the fitting. See 7-6, Brake
Manifold Components .
5 Working under the dashboard, locate the
hydraulic hose at port L of the steering orbitral.
6 Working at the front axle, locate the hydraulic
hose connected to the front axle steer cylinder
at the operator's compartment side of the
machine. Tag, disconnect and plug the
hydraulic hose. Cap the fitting.
7 Tag, disconnect and plug the hydraulic hoses at
ports SUP, SUR and SUT of the secondary
function manifold. Cap the fitting.
8 Tag, disconnect and plug the hydraulic hose at
port SULS of the primary function manifold.
Cap the fitting.
9 Tag, disconnect and plug the hydraulic hose at
port JP of the secondary function manifold. Cap
the fitting.
GTH-1048 • GTH-1056
Section 4 • Repair Procedures
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
4 - 23