6.26. Remove the Reinforcement
Angles (L, R) and the
Connection Plate (A, B, C, D)
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered), with the
plasma panel surface facing downward.
Spread a soft cloth or similar on the table for protection, so
the panel surface is not scratched.
2. Remove the screws (×2
Reinforcement Angles (L, R).
3. Remove the screws (×2
Connection Plate (A, B, C, D).
6.27. Remove the C1-Board
1. Remove the Fan unit (Middle/R). (See section 6.11.)
2. Remove the Esc-fixing metal (A) and (B). (See section 6.18.
and 6.19.)
3. Remove the Reinforcement Angle (R). (See section 6.26.)
4. Remove the flexible cables holder fastening screws (×10
).
5. Disconnect the flexible cables (CA1, CA2, CA3, CA4 and
CA5).
6. Disconnect the flexible cables (C10 and C11).
7. Remove the screws (×6
each) and remove the
each) and remove the
) and remove the C1-Board.
6.28. Remove the C2-Board
1. Remove the Fan unit (Big and Middle/L). (See section
6.12.)
2. Remove the Esc-fixing metal (B). (See section 6.19.)
3. Remove the flexible cables holder fastening screws (×10
).
4. Disconnect the flexible cables (CA6, CA7, CA8, CA9, and
CA10).
5. Disconnect the flexible cables (C21, C22, C24 and C25).
6. Remove the screws (×6
6.29. Remove the C3-Board
1. Remove the Fan unit (Big and Middle/L). (See section
6.12.)
2. Remove the Esc-fixing metal (A) and (B). (See section 6.18.
and 6.19.)
3. Remove the Reinforcement Angle (L). (See section 6.26.)
4. Remove the flexible cables holder fastening screws (×10
).
5. Disconnect the flexible cables (CA11, CA12, CA13, CA14
and CA15).
6. Disconnect the flexible cable (C31).
7. Disconnect the coupler (C35).
8. Remove the screws (×6
17
TH-65PX600U
) and remove the C2-Board.
) and remove the C3-Board.