Chevrolet 1960 Corvair Owner's Manual page 26

ammonia or soda solution and flush with clear
water. Check state of charge regularly, espe-
cially in freezing weather, for an undercharged
battery may freeze and break.
16. FUEL FILTER
Every 15,000 miles-Replace filters, located in each
carburetor inlet. If flooding occurs, replace more
often.
17. BRAKE MASTER CYLINDER
Check frequently and maintain fluid level at mark
inside reservoir below filler opening, using G. M.
Hydraulic Brake Fluid, Super No. 11.
If
addition
of fluid is required more often than · e very 1000
miles the entire system should be checked for
leaks.
18. PARKING BRAKE & CLUTCH PULLEYS
AND CABLES
Every 10,000 miles-Lubric. a te pulleys under dash.
Remove the tunnel cover under vehicle and lubri-
cate pulleys and cable bearing points with lub-
riplate. lubricate gearshift lever ball and socket
and shift rod universal joint at transmission con-
nection with lubriplate.
BODY LUBRICATION POINTS
Most body lube points do not need frequent, heavy
23
lubrication as does the chassis. However, periodic checks
of certain points on the Corvair body, and lubrication
when needed will eliminate annoying squeaks and
noises . Be careful not to over-lubricate. Wipe off all
surplus lubricant.
The following items should be lubricated periodically :
1. DQQr Hinges-Wipe off dirt and apply Lubriplate.
2. Door Lock Striker-Wipe off dirt and apply stick type lu-
bricant.
3. Door Bottom Drain Hole Sealing Strip-Apply silicone rub-
ber lubricant.
4 . Door Jamb Switch-Apply Lubriplate.
5 . Rear Door Weatherstrip-Apply silicone rubber, lubricant.
6 . Front and Rear Compartment Lid Lock-Apply Lubriplate.
7. Front Compartment Lid Torque Rods-Apply dripless oil to
bearing points.
8. Gas Tank Filler Door Hinge-Apply dripless oil.
9. Glove Box Door Hinge-Apply dripless oil.
10. Rear Folding Seat Back Support Link Assembly & Filler
Panel Hinge-Apply dripless Qil to bearing points.
The following items moy be lubricated whenever
access to the item is availoble:
11. Door Outsi.de Handle Lock Cylinder Shaft-Apply Lubri-
plate.
12. Door Window Regulator and Cams-Apply Lubriplate.
13 . Door Lock Parts-Apply Lubriplate .
14. Door Locking Mechanism-Apply Lubriplate .
15. Front and Rear Compartment Hinges-Apply Lubriplate.