Plumbing Connections - Newco CX-TOUCH Operation Manual

This machine must be connected to a cold water system with operating pressure between 20 and 90 psi
(138 and 620 kPa) from a 1/2" or larger supply line. A shut-off valve should be installed in the line before
the machine. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to
50 psi (345 kPa). The water inlet fitting is 1/4" flare.
NOTE –Newco recommends 1/4" copper tubing for installations of less than 25 feet and
25 feet from the 1/2" water supply line. A tight coil of copper tubing in the water line will facilitate moving
the machine to clean the counter top. Newco does not recommend the use of a saddle valve to install the
brewer. The size and shape of the hole made in the supply line by this type of device may restrict water
flow.
This equipment must be installed to comply with the Basic Plumbing Code of the Building Officials and
Code Administrators International, Inc. (BOCA) and the Food Service Sanitation Manual of the Food and
Drug Administration (FDA). For models installed outside the U.S.A., comply with the applicable Plumbing
/Sanitation Code.
Flush the water line and securely attach it to the inlet fitting at the rear of the brewer.
Turn on the water supply and check for leaks.
Plumber's Installation Instructions
CAUTION:
Disconnect Power to machine before proceeding with plumbing installation.
1) Attach water line to water filter, rear of machine.
2) Flush water line before installing machine. Machine should be connected to COLD WATER LINE
ONLY.
3) Water pressure should be at least 40 lbs. For less than a 25 ft run, use 1/4" copper tubing and
connect to 1/2" or larger water line. For longer runs, use 3/8" copper tubing & connect to 1/2" or
larger water line and provide an adapter fitting for connection to the brewer.
line is necessary for this machine.
4) If installed with saddle valve, the valve should have a minimum of 1/8" porthole for up to 25 ft run,
and 5/16" porthole for over 25 ft runs.
5) Manufacturer recommends connecting to copper tubing.
The brewer must be disconnected from the power source until specified in
Installation Instructions.
Determine the available on-site electrical requirements
Refer to Data Plate on the Brewer, and local/national electrical codes to determine
circuit requirements.
CAUTION – Improper electrical installation will damage electronic components.

Plumbing Connections

Electrical Hook-Up
WARNING
8
3
⁄8" for more than
A dedicated water