Maintenance; Cleaning The Print Head - Sagem Photo easy 150 User Manual

8 M
AINTENANCE
Continuous lines across the length of your photographs may be caused by dirt particles stuck to
the printhead.
You will need a methylated alcohol
tips ("Q-tips").
Switch off your printer, disconnect the main cables and wait for five minutes; since the
print head operates at a high temperature, there is a risk of burning if you touch it.
1 - Open the cartridge flap. Press on the locking lever and pull out the film cartridge.
2 - Pull out the paper tray.
3 - Turn the printer upside down to remove the lower hatch.
4 - Clean the heating line of the print head carefully using a cotton bud.
5 - Replace the lower hatch, turn the printer right side up, connect the mains cable and switch
on the printer.
Warning -
Replace the film cartridge. Take care that the film is taut before inserting the cartridge into
its compartment. Check that the locking lever is pushed down correctly and close the flap.
Push the paper tray back into place until the locking system clicks.
1.
C
LEANING THE PRINT HEAD
Never touch the print head with your fingers or any object that might scratch it.
1
4
Do not use corrosive chemicals, they may damage your printer.
1
based cleaning product and some off-the-shelf cotton
2
5
- 21 -
3