Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Recycler 20339 Operator's Manual

1. Handle lock
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 5).
1. Recoil-starter rope
Figure 4
2. Pin
Figure 5
2. Rope guide
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine, but it does come with a bottle of oil. Before
starting the engine, fill the engine with oil.
Max. fill: 0.59 L (20 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
Note: When the crankcase is empty, pour about 3/4 of
the crankcase capacity of oil in the crankcase, then do the
following:
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Dipstick
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
5. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, slowly pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
6
(Figure 6).
Figure 6
(Figure 6).
3