Setup; Installing The Handle - Toro 22293 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2
Hex-head-flange bolt (5/16 x 1-1/2 inches)
2 Carriage bolt (5/16 x 1-1/2 inches)
4 Flange nut (5/16 inch)
Procedure
1. Remove the cable guard from the handle (Figure 3) by
removing the 2 carriage bolts and 2 locknuts that hold
the cable guard to the handle.
Description
Handle
Hex-head-flange bolt (5/16 x 1-1/2
inches)
Carriage bolt (5/16 x 1-1/2 inches)
Flange nut (5/16 inch)
No parts required
No parts required
Qty.
1
2
Install the handle.
2
4
–
Fill the crankcase with oil.
–
Adjust the self-propel drive.
1. Cable guard
2. Locknut (2)
3. Carriage bolt—1/4 x 1-1/2
inches (2)
Note: Save the guard, the carriage bolts, and the
locknuts so that you can install it onto the handle later
in this procedure.
2. Install the handle ends onto the mower housing with
2 hex-head-flange bolts (5/16 x 1-1/2 inches) and 2
flange nuts (5/16 inch) as shown in Figure 3.
3. Set the machine to the desired cutting height; refer to
Adjusting the Cutting Height (page 11).
7
Use
Figure 3
4. Flange nut—5/16 inch (2)
5. Hex-head-flange
bolt—5/16 x 1-1/2 inches
(2)