Filling The Crankcase With Oil - Toro 22293 Operator's Manual

4. Stand behind the machine in the operating position to
determine the handle height that is most comfortable
for you (Figure 4).
Figure 4
1. Handle
2. Handle bracket (2)
3. Highest handle height
5. Secure the handle onto the handle brackets at your
desired handle height with 2 carriage bolts (5/16 x
1-1/2 inches) and 2 flange nuts (5/16 inch) as shown
in Figure 5.
Important: Ensure that the bolt heads are on
the inside of the handle and the nuts are on the
outside of the handle.
Figure 5
1. Carriage bolt—5/16 x
1-1/2 inches (2)
2. Handle bracket (2)
6. Position the cable guard onto the handle with the
cable(s) inside the guard, and secure the guard to the
4. Medium handle height
5. Lowest handle height
3. Flange nut—5/16 inch (2)
handle with the 2 carriage bolts and the 2 locknuts that
you previously removed (Figure 3).
Important: Ensure that you do not pinch the
cable(s) to the handle with when you install the
cable guards onto the handle.
2

Filling the Crankcase with Oil

No Parts Required
Procedure
The engine crankcase is shipped without oil. Before
starting the engine, fill the crankcase with oil. The engine
crankcase (with oil filter) can hold 0.85 L (29 oz) of oil. Use
only high-quality SAE 10W-30 weight detergent oil that has
the American Petroleum Institute (API) service classification
SH, SJ, or equivalent.
Before each use, ensure that the oil level is between the Add
and the Full marks on the dipstick (Figure 6).
1. Dipstick
2. Full mark
Note: When the crankcase is empty, pour about 3/4 of the
crankcase capacity of oil in the crankcase, then follow the
procedure in this section.
1. Move the machine onto a level surface.
2. Clean around the dipstick (Figure 6).
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
8
Figure 6
3. Add mark