Engine Maintenance; Servicing The Air Cleaner; Changing The Engine Oil - Toro 22155TE Operator's Manual

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily
Yearly
1. Press down on the latch tabs on top of the air cleaner
cover (Figure 37).
Figure 37
1. Latch tabs
2. Open the cover (Figure 38).
Figure 38
3. Remove the air filter (Figure 39).
Figure 39
1. Air cleaner cover
4. If the air filter is damaged or is wet with oil or fuel,
replace it.
2. Air filter
5. If the air filter is dirty, tap it on a hard surface several
times or blow compressed air less than 30 psi (207
kPa) through the side of the filter that faces the
engine.
Note: Do not brush the dirt off the filter; brushing
forces dirt into the fibers.
6. Remove dirt from the air cleaner body and cover
using a moist rag. Do not wipe dirt into the air
duct.
7. Install the filter into the air cleaner.
8. Close the cover.

Changing the Engine Oil

Service Interval: After the first 5 hours
Yearly
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Remove the dipstick (Figure 40).
3. Tip the mower onto its side, with the air filter up,
to drain the used oil out through the oil fill tube
(Figure 41).
20
Figure 40