Issues Resolved In Release 4.1.0 Hf1 - Mitel 6800 Series Release Notes

Mitel 6800 Series SIP Phones 4.1.0 HF1 Release Notes

ISSUES RESOLVED IN RELEASE 4.1.0 HF1

This section describes the issues resolved on the SIP phones in Release 4.1.0 HF1.
The following table provides the issue number and a brief description of each fix:
Note: Unless specifically indicated, the resolved issues below apply to the all the 6800
SIP phones.
ISSUE NUMBER
Configuration
DEF40406
SIP
DEF40439
User Interface
DEF40368/CLN40446
XML
DEF39942/CLN40445
DEF40328
3
DESCRIPTION OF FIX
When using the phones with the MiCloud Telepo for Service Providers
platform, after a hard reboot the phone would at times go through the reboot
cycle again before reaching an idle working state. This issue has been
resolved.
When using the phones with the MiCloud Telepo for Service Providers
platform, an issue was observed whereby existing BLF and call park/pickup
subscriptions were lost when attempting to update the phones'
configuration without rebooting using the check-sync event method. This
issue has been fixed.
M685i Expansion Module: When the screen language on the phone and
expansion module was changed to Greek, some Greek characters were
not being displayed properly on the expansion module. This issue has
been corrected.
6865i: An issue was observed whereby the phone was not displaying some
XML TextScreen elements in the correct position on screen. This issue has
been resolved.
When using the phones with the MiVoice Office 400 call manager, XML
PhoneStatus messages with "type=alert" were not being processed by the
phone if on an active call. This issue has been fixed.