Side Discharge Chute - Toro Recycler 20651 Operator's Manual

Walk power lawn mower
Hide thumbs Also See for Recycler 20651:
Table of Contents

Advertisement

The discharge door in the lawn mower housing is now
open and the bag is locked into position. The latch
should seat in the bottom of the notch.
1
Figure 38
1. Handle latch locked in bag
notch
DANGER
POTENTIAL HAZARD
Grass clippings and other objects can be
thrown from an open discharge tunnel.
WHAT CAN HAPPEN
Objects thrown with enough force could cause
serious personal injury or death to the operator
or bystander.
HOW TO AVOID THE HAZARD
Never open the door on the discharge tunnel
when the engine is running.
DANGER
POTENTIAL HAZARD
A worn grass bag could allow small stones and
other similar debris to be thrown in operator's
or bystander's direction.
WHAT CAN HAPPEN
Thrown objects can cause serious personal
injury or death to the operator or bystanders.
HOW TO AVOID THE HAZARD
Check the grass bag frequently. If it is
damaged, install a new genuine Toro
replacement bag that has this or a similar
warning.
2
548
2. Notch in bag door latch
Emptying the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Lift the door latch until it clears the bag notch and
move the discharge door handle forward (Fig. 37).
3. Grasp the bag frame handle and the rear of the grass
bag and lift the bag off the lawn mower.
4. Gradually tip the bag forward to empty clippings.

Side Discharge Chute

Installing the Side Discharge Chute
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 7).
3. Remove the knob and side cover clamp, then replace
the knob in the hole and save the clamp for future use
(Fig. 32).
4. Lift up on the side opening cover (Fig. 32).
5. Slide the chute over the opening with the slots in the
chute lined up with the tabs under the cover (Fig. 39).
2
m–4196
1. Side opening cover
2. Side discharge chute
6. Close the cover.
Removing the Side Discharge Chute
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 7).
3. Open the side opening cover and remove the side
discharge chute (Fig. 39).
4. Close the cover.
25
4
Figure 39
3. Tab
4. Slot
1
3

Advertisement

Table of Contents
loading

Table of Contents