Connecting An Fm Outdoor Antenna; Connecting An Am Outdoor Antenna; Directional Linkage; Connecting The Antenna Cable To The 75/300 Ω Antenna - Onkyo TX-SR601E Instruction Manual

Onkyo instruction manual av receiver tx-sr701/701e tx-sr601/601e
Hide thumbs Also See for TX-SR601E:
Table of Contents

Advertisement

Connecting antennas

Connecting an FM outdoor antenna

Make sure to follow the general rules given below:
• Keep the antenna away from noise sources (neon signs, busy
roads, etc.).
• It is dangerous to put the antenna close to power lines. Keep it
well away from power lines, transformers, etc.

Connecting an AM outdoor antenna

If reception is poor with the indoor AM antenna, stretch out the
outdoor antenna (16 feet (5 meters) or more) above a window or
outside.
• Keep the indoor AM loop antenna connected. Do not remove it.
Outdoor antenna
(Indoor)
AM loop antenna
Note:
If you are using the TX-SR701/701E/601/601E worldwide model in
a region where AM frequencies are delineated by 10-kHz steps, be
sure to set the "AM Frequency Step" Setup setting accordingly (see
page 55).
30
ANTENNA
AM
FM 75
ZONE 2
LINE OUT
L
R
VIDEO 3
VIDEO 2
VIDEO 1
DVD
MO
AL
OU
IN
OUT
IN
OUT
IN
IN
ANTENNA
AM
FM 75
ZONE 2
LINE OUT
L
R
VIDEO 2
VIDEO 1
DVD
VIDEO 3
M
L
O
IN
OUT
IN
OUT
IN
IN

Directional linkage

Do not use the same antenna for both FM and TV (or VCR)
reception since the FM and TV (or VCR) signals can interfere with
each other. If you must use a common FM/TV (or VCR) antenna,
use a directional linkage type splitter.
To receiver
Connecting the antenna cable to the 75/300 Ω
antenna adapter (For all models other than USA
& Canadian models and European models)
Connecting the 300 Ω ribbon wire:
Loosen the screws on the adapter and wrap the wires of the ribbon
wire around these screws. Then tighten the screws down with a
screwdriver.
Connecting the coaxial cable:
1. With your fingernail, or a small screwdriver, press the
stoppers of the 75/300 Ω antenna adapter outward
and remove the cover.
2. Remove the transformer wire A from slit B and insert
it into slit C.
3. Prepare the coaxial cable as shown in the diagram.
4. Connect the 75/300 Ω antenna adapter to the coaxial
cable.
1. Insert the end of the cable.
2. Clamp it in place with pliers.
3. Reinstall the cover.
1
2
Slit C
To TV (or VCR)
Outdoor
antenna
300 Ω
ribbon wire
3, 4
6
3
6
mm
mm
mm
Slit B
5/8"
(15mm)
Wire A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx-sr701Tx-sr701eTx-sr601

Table of Contents