Drive System Maintenance; Adjusting The Control Bar - Toro 30031 Operator's Manual

Figure 32
1. Fuse, 7.5 amp, blade type
Drive System
Maintenance

Adjusting the Control Bar

1. Check the gap between upper control bar and
fixed bar with wheel drive fully engaged. The
gap should be approximately 1 to 1-1/4 inch
(25-32 mm) (Figure 33).
Note: The upper control bar and fixed bar
must be parallel when the upper control bar
is in the engaged, drive, neutral, or brake
positions.
Figure 33
1. Upper control bar
2. Parking brake lever
3. Fixed control bar
2. Check the operation. If adjustment is required,
remove hairpin cotter, washer and clevis pin
securing control rod fitting to idler bracket
(Figure 34).
3. Thread the rod fitting up or down on the rod
until the proper position is attained and install
the rod fitting to the idler bracket with the
clevis pin, washer and hairpin cotter.
Figure 34
1. Control rod and tting
2. 3-1/2 inch (89 mm)
3. Idler bracket
4. Clevis pin
30
4. Handle
5. 1 to 1-1/4 inch (25-32mm)
gap
5. Washer
6. Hairpin cotter pin
7. Rod tting
8. Hole F