Lubricating The Caster And Wheel; Greasing The Transmission; Greasing The Pto Drive Belt Idler; Bearings - Toro 30031 Operator's Manual

Commercial walk-behind mower for floating deck, t-bar, gear with 91cm turbo force cutting unit

Hide thumbs Also See for 30031:

Table of Contents

2. Stop the engine, remove the key, and wait for

all moving parts to stop before leaving the

operating position.

3. Clean the grease ﬁttings with a rag. Make

sure to scrape any paint off the front of the

ﬁtting(s).

4. Connect a grease gun to the ﬁtting. Pump

grease into the ﬁttings until grease begins to

ooze out of the bearings.

5. Wipe up any excess grease.

Lubricating the Caster and

Wheel Bearings

1. Lubricate the front caster wheel bearings and

front pivots (Figure 20).

2. Raise the rear of the machine and use jack

stands to support the machine.

3. Remove the rear wheel and tire assemblies.

4. Remove rear wheel grease cap. Lubricate the

rear wheel bearing (Figure 20).

5. Install the grease cap.

6. Install the rear wheel and tire assembly.

Note: Make sure the rear wheel grease caps

are removed before lubricating rear wheels.

Figure 20

Lubricate the transmission couplers located in the

back of the machine (Figure 21).

Figure 21

Greasing the PTO Drive Belt

Idler and Mower Deck Belt

Idler

Grease the idler pulley pivot(Figure 22).

Figure 22

Table of Contents