Using Computer Setup (F10) Utility - HP Z228 Maintenance And Service Manual

Using Computer Setup (f10) Utility

To start Computer Setup (f10) Utility, complete the following steps:
1. Turn on or restart the computer.
2. Repeatedly press
NOTE:
repeatedly press
3. A choice of five headings appears in the Computer Setup (f10) Utility menu: File, Storage, Security,
Power, and Advanced.
4. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down) keys
to select the option you want, then press enter. To return to the Computer Setup (f10) Utility menu,
press esc.
5. To apply and save changes, select File > Save Changes and Exit.
●
If you have made changes that you do not want applied, select Ignore Changes and Exit.
●
To reset to factory settings or previously saved default settings (some models), select Apply
Defaults and Exit. This option will restore the original factory system defaults.
NOTE:
CAUTION:
changes because the CMOS might become corrupted. It is safe to turn off the computer only after exiting
Computer Setup (f10) Utility screen.
Heading
File
Storage
Security
Power
Advanced
12 Chapter 2 System management
f10 when the monitor light turns green.
If you do not press f10
f10 when the monitor light turns green.
Not all settings shown in the following sections are available for all models
Do NOT turn the computer power OFF while the BIOS is saving Computer Setup (f10) Utility
at the appropriate time, you must restart the computer and again
Table
Computer Setup (f10) Utility—File on page 13
Computer Setup (f10) Utility—Storage on page 14
Computer Setup (f10) Utility—Security on page 16
Computer Setup—Power on page 19
Computer Setup—Advanced on page 20