Connections For Remote Control - Onkyo HT-R8230 Instruction Manual

Connections for remote control (

The terminal on the HT-R8230 is for connecting other Onkyo
components equipped with the same
component is -connected, you can point the remote controller
supplied with the HT-R8230 at the sensor on the HT-R8230 and
operate that component without having to switch remote
controllers. In addition, by connecting components to the
terminal, you can also perform the system operation given below.
To connect components using the
cable from this
component. An cable comes with every cassette tape deck, CD
player, and DVD player that has an
Example: Onkyo DVD Player
cable
HT-R8230
connector
Ex: Onkyo DVD player
connector
Ex: Onkyo cassette tape
deck
Connection example when there is more
than one Onkyo components equipped with
terminals
16
terminal. When a
terminal, simply connect a
terminal to the terminal of the other
terminal.
REMOTE
COAXIAL
CONTROL
L
R
DIGITAL ANALOG
OUTPUT OUTPUT
FM
AM
ANTENNA
75
Power on/ready function
When the HT-R8230 is in the standby state, if an
component is turned on, then the HT-R8230 also turns on and the
input source selected at the HT-R8230 automatically switches to
that component.
If the power cord for an
the AC OUTLET on the HT-R8230, or if the HT-R8230 is turned
on, this function will not work.
Direct change function
When the play button is pressed at an
the input source selected at the HT-R8230 automatically changes to
that component.
Power off function
When the HT-R8230 is placed in the standby state, all
connected components are also automatically put in the standby
state.
Be sure to connect using
the audio connection
cable.
FRONT FRONT
SPEAKERS B SPEAKERS A
R L R
Notes
• Connect the plugs securely.
• Be sure to connect to the
• For proper operation the audio connection cables must be
connected. This applies to both remote and standard operation.
• If a component has two
connect to the HT-R8230. The other one can be used to daisy
chain with another component.
• With Onkyo DVD players, you can enter the manufacturer code
so that you can operate the DVD player directly with the remote
controller without connecting the
• Do not connect the AV Receiver's
component other than an Onkyo product. It may cause
malfunction.
• Certain component models may not be able to control the
HT-R8230.
)
-connected component is connected to
CENTER SURROUND
SPEAKER SPEAKERS
L R L
DO NOT connect the
power cord at this
time.
connectors using the
terminals, you can use either one to
terminals (see page 33).
-connected
-connected component,
-
AC OUTLET
cable.
connector to any