1. Test S/W
Preparation for using H/W Test Code stored at the flash memory
At the time of the power up, connect the serial cable to the service port, locate the cursor at the TeraTerm
window, and turn on the power of the LST-3410A by pressing "shift"+"D" at the PC keyboard.
Enter "svcLST3410" as the password.
(The password is capital sensitive)
Section possible to check by using H/W Test Code
Initial screen
======================================================
ROM TEST Program For PVR-SET (2003/09/26)
======================================================
--------------------- System Info ----------------------
Processor = 405GP, PVR: 40110145
Processor speed = 200 MHz
PLB speed = 100 MHz
OPB speed = 33 MHz
Ext Bus speed = 33 MHz
PCI Bus speed = 33 MHz (Sync)
Amount of SDRAM = 32 MBytes
Internal PCI arbiter enabled
--------------------------------------------------------
******************* TEST MENU******************
1 - System SDRAM Test
2 - HD-II Memory Test
3 - HD-II DMA Test
4 - HD-II Audio Decoder Test
5 - PCF8584-A(TUNER/MICOM/GEMSTAR Test)
6 - CPU I2C(EEPROM/VSB/4450/3226/170B) Test
7 - PCI Device(TPN-II/IDE/KFIR) Test
8 - IDE R/W Test
9 - Video Display Test
A - FLASH Memory Test
B - FLASH Program from Serial port
C - Flash Program from HDD
D - Ethernet Ping Test
E - TI-1394 Test
F - GPIO Test
->
The total test is performed by entering "T."
TEST S/W
3-11