Using The Wiper/Washer (Pelco Protocol) - Bosch MIC-71 series Operation Manual

68 en | Operation
13.4

Using the Wiper/Washer (Pelco Protocol)

To activate the washer/wiper in Pelco protocol, follow these steps:
1. From the SETTINGS page > Illumination/Wiper > Wiper/washer, click Start, and then exit
the menu.
2. Position the camera so that the nozzle of the washer will spray the camera window.
3. Press 62 and then Preset. Press and hold "Preset" for 2 seconds until the text "Scene 62
Stored" appears on the OSD.
Note: If you already have a preset stored at that position, the system prompts you to overwrite
the current scene.
4. Activate the wash/wiper function. Press 1 and then press AUX-ON on the keyboard. The
camera moves to preset 62. The nozzle sprays cleaner onto the camera window, and then the
wiper wipes the window. The camera then returns to where it was positioned previously, or it
continues to perform the tour that it was performing when you activated the wash/wipe
function.
Notice!
Depending on your camera settings, your monitor may display a freeze frame image of the
wiper during or at the end of the wipe cycle. If you prefer not to see this freeze frame, you
can turn off the Freeze Frame on Preposition in the PTZ Setup menu.
2016.02 | 4.0 | Operation Manual
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
Bosch Security Systems