Servicing The Muffler And Exhaust Ports; Adjusting Idle Speed; Storage; Emission Control Information - Toro 53047 Operator's Manual

Backpack blower
Hide thumbs Also See for 53047:
Table of Contents

Advertisement

Servicing the Muffler and
Exhaust Ports
The muffler must be removed and serviced after each
100 hours of use. The exhaust ports must be cleaned
and inspected at the same time. Contact an authorized
Toro dealer for this service.

Adjusting Idle Speed

Idle speed is the only available adjustment.
Do not tamper with the carburetor setting to increase
the maximum engine speed.
If adjustment is needed, have it performed by your
authorized Toro service dealer. Carburetor
adjustments are made at the factory and are not
adjustable without disassembling the carburetor.

Storage

For long-term storage of the backpack blower, first
perform all regular maintenance procedures and
needed repairs.
1.
Empty the fuel tank. Disconnect the fuel-return
line from the carburetor. Then gently hold the
tickler lever down while pumping the primer
bulb until fuel stops discharging from the
fuel-return fitting.
2.
Start the engine and allow it to run until it stops.
Pull the starter cord a few times to remove any
excess fuel from the engine.
3.
Remove the spark plug and insert a small
amount of oil into the cylinder. Slowly pull the
starter cord and bring the piston to a position
closest to the spark plug hole. Re-install the
spark plug.
4.
Apply a thin coating of oil to all the metal
surfaces and store the backpack blower in a dry
place.
Emission Control
Information

Fuel Information

THIS ENGINE IS CERTIFIED TO OPERATE ON
UNLEADED REGULAR GRADE GASOLINE
ONLY. A minimum of 87 octane of the antiknock
index is recommended. The antiknock index is posted
on service station pumps in the USA.

Emission Control Information

To protect the environment in which we all live,
Kawasaki has incorporated an exhaust emission
control system (EM) in compliance with acceptable
regulations of the California Air Resources Board.
Exhaust Emission Control
System (EM)
The exhaust emission control system applied to this
engine consists of a carburetor and an ignition system
having optimum ignition timing characteristics.
The carburetor has been calibrated to provide lean
air/fuel mixture characteristics and optimum fuel
economy with a suitable air cleaner and exhaust
system.

Maintenance and Warranty

Proper maintenance is necessary to ensure that your
engine will continue to have low emission levels.
This Operator's Manual contains those maintenance
recommendations for your engine. Those items
identified in the Period Maintenance Chart are
necessary to ensure compliance with the applicable
standards.
The Toro Limited Emission Control System Warranty
requires that you return your engine to an authorized
Toro engine dealer for remedy under warranty. Please
read the warranty carefully and keep it valid by
complying with the owner's obligations it contains.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proline bp6900

Table of Contents