Kenwood DDX7015 Service Manual page 28

DDX7015/7025/7035
DDX7045/7065
Screen Adjustment
1) Graphic Screen
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39
0
1 AV input : Monoscope/ NTSC
2
3
4
5
6
<
7
8
9
10
11
12
13
14
Using the touch panel, adjust so that the mono-scope screen
comes at the center.
Adjust with the horizontal direction of the monoscope.
Enlargement (Font A and B)
Left side
Slide the right and left notches to outside
the screen by 2 or 3 dots.
Left side q (Slide 2 dots to outside)
Font A
One red dot can be seen on.
Font B
Blue cannot be seen on the left side.
Two white dots can be seen.
Left side w (Slide 3 dots to outside)
Font A
Red dots cannot be seen on the left side.
Font B
Blue cannot be seen on the left side.
One white dot can be seen.
OK if either q or w on the left side.
OK if either q or w on the right side.
q and w combination are all OK.
28
ADJUSTMENT
NEXT
GRAPHIC 1
>
CANCEL
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39
0
1 font A
Full display
2
3
4
5
6
GRAPHIC 2
<
7
8
9 font B
10
11
12
13
14
Turn TC1 and adjust so that the font screen comes at the cen-
ter.
Adjust while watching the fonts to the right and left.
Right side
Right side q (Slide 2 dots to outside)
Font A
One blue dot can be seen on the right side.
Font B
Red cannot be seen on the right side.
Two white dots can be seen.
Right side w (Slide 2 dots to outside)
Font A
Blue dots cannot be seen on the right side.
Font B
Red cannot be seen on the right side.
One white dot can be seen.
font A
NEXT
>
font B
CANCEL