Kenwood DDX7015 Service Manual page 21

Writing Serial number data screen
Serial data writing for each unit.
1) Serial number input screen
– – – – – – – –
1
4
7
Clear Cancel
• Key specification
0~9 : 10key use for serial number
Clear : Clear for on entry serial number data.
Cancel : Change to Service information screen
2) Serial number writing screen
* * * * * * * *
Clear Cancel
• Key specification
Enter : Writing for serial number data for the unit (Complete :
Writing OK, NG : Miss writing)
Press to cancel key when exit this function.
You can try again adjustment when if appears on serial num-
ber write NG.
Clear : Clear for on entry serial number data
Cancel : Change to Service information screen
TEST MODE
2 3
5 6
8 9
0
Enter
DDX7015/7025/7035
DDX7045/7065
Chroma adjustment screen
Chroma IC adjustment uses an accessory remote controller.
(The selector of the remote controller is set the Audio mode)
Initialized Chroma adjustment data. (for service information
screen)
CH :
** * * * * *
VAL
**
• Key specification (for remote controller)
DIRECT : Chroma adjustment mode on/off (EEPROM Writ-
ing)
PLAY/PAUSE : Chroma adjustment value fixed/cancel
7 (10 key) : Chroma adjustment (previous)
8 (10 key) : Chroma adjustment value change (up)
9 (10 key) : Chroma adjustment (reverse)
0 (10 key) : Chroma adjustment value change (down)
• Adjustment item
1. CH16 : VCO freerun
2. CH6 : Bright
3. CH13 : Contrast
4. CH5 : Black limiter
5. CH10 : White limiter
6. CH2 : Y gain
7. CH11 : Gamma1
8. CH12 : Gamma2
9. CH8 : R sub bright
10. CH9 : B sub bright
11. CH14 : R sub contrast
12. CH15 : B sub contrast
13. CH1 : VCOM
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~7Fh
value 00h~7Fh
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~FFh
value 00h~FFh
21