Priority Watch; Add/Remove Channels From Scan Memory - Uniden UH5045 Owner's Manual

Operation

Priority Watch

To switch Priority Watch On/Off;
1. Press [MENU/ENTER] two times. The Priority Watch setting flashes.
2. Turn the Rotary Channel Selector at the base or press
MIC to change the setting between ON or OFF.
3. Press [MENU/ENTER] to store the setting.
4. Press and hold [MENU/ENTER] to exit from the menu mode.
If SCAN is deactivated while it is tuned to an active channel, the UHF
CB Radio will stay on that active channel.
If none of the channels are active, the UHF CB Radio will reinstate the
NOTE
scan start channel.
If OS/GS Scanning is initiated when there are no channels programmed
in OS/GS memory, an error tone will be heard and scanning will not
start (see Programming Scan Channels - below).
NOTE

Add/Remove Channels from SCAN Memory

Select which Scanning Mode you wish to use
- OS or GS.
Select the channel you want to store.
Press to [MEM] store. MEM icon appears
and a short tone beep is heard.
To remove the channel from SCAN
memory, press [MEM] once more.
The MEM icon disappears.
UNIDEN UH5045
24
on the Remote SPK/
UHF CB Transceiver