Changing The Mower Deck Front-To-Rear Pitch; Checking The Mower Deck Side-To-Side Height - Toro 30488 Operator's Manual

Changing the Mower Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by adjusting the
front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted
1. Caster wheel
2. Carrier frame
3. Front height-of-cut pins
2. To raise the front of the deck, loosen the jam nut and
rotate the front pin clockwise
3. To lower the front of the deck, loosen the jam nut and
rotate the front pin counterclockwise
4. Position the blades front-to-rear.
5. Measure at the C and D locations
level surface to the cutting edge of the blades.
6. Check the side-to-side leveling of the cutting unit.
7. Tighten the jam nuts
(Figure 72).
Figure 72
4. Jam nut
5. Ball joint
(Figure 72).
(Figure
(Figure 71) from a
(Figure 72).
Checking the Mower Deck
Side-to-Side Height
1. Adjust the rear tire pressure to specifications; refer to
Checking the Tire Pressure (page
2. Position the blades side-to-side.
3. Measure at C and D locations from a level surface to
the cutting edge of blade tips
1. Measure from a level
surface
4. The difference between measurements C and D should
be no more than 6 mm (1/4 inch).
72).
50
34).
(Figure 73).
Figure 73
2. Measure blade at points C
and D