Changing The Mower Deck Front-To-Rear Pitch; Checking The Mower Deck Side-To-Side Height - Toro 30074 Operator's Manual

36 inch Mower Deck shown
Changing the Mower Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by adjusting the
front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted
1. Caster sheel
2. Carrier frame
3. Front height-of-cut pins
2. To raise the front of the deck, loosen the jam nut and
rotate the front pin clockwise
3. To lower the front of the deck, loosen the jam nut and
rotate the front pin counter clockwise
4. Position the blades front-to-rear.
5. Measure at C and D locations
surface to the cutting edge of the blades.
6. Check the side-to-side leveling of the cutting unit.
7. Tighten the jam nuts
Figure 67
(Figure 68).
Figure 68
4. Jam nut
5. Ball joint
(Figure 68).
(Figure
(Figure 66) from a level
(Figure 68).
Checking the Mower Deck
Side-to-Side Height
1. Adjust the rear tire pressure to specifications; refer to
Drive System Maintenance (page 30)
2. Position the blades side-to-side.
3. Measure at C and D locations from a level surface to
the cutting edge of blade tips
4. For 36 inch mower decks use
1. Measure from a level
surface
5. The difference between measurements C and D should
be no more than 6 mm (1/4 inch).
68).
43
(Figure
Figure
Figure 69
48 inch Mower Deck shown
2. Measure blade at points C
and D
Figure 70
36 inch Mower Deck shown
.
69).
70.