Preparing The Remote Controller; Inserting The Batteries; Using The Remote Controller - Onkyo DV-S155X Instruction Manual

DV-S155X-En.book Page 12 Saturday, July 24, 2004 2:20 PM

Preparing the Remote Controller

Inserting the batteries

1
1 Detach the battery cover.
2 Insert two size-AA/R6 batteries.
Be sure to match the + and – ends of the batteries with to diagram inside the battery
compartment.
3 Attach the battery cover.
• Do not mix new batteries with old batteries or different kinds of batteries.
• To avoid corrosion, remove the batteries if you do not intend to use the remote controller
for a long time.
• Remove dead batteries immediately to avoid damage from corrosion. If the remote con-
troller does not operate smoothly, replace both batteries at the same time.
• The batteries should last for about six months, although this will vary with usage.

Using the remote controller

Remote control sensor
DV-S155X
30˚
30˚
RC-522DV
Point the remote controller toward the remote control sensor.
• Place the unit away from strong light, such as direct sunlight or inverted fluorescent light,
which can prevent proper operation of the remote controller.
• Using another remote controller of the same type in the same room or using the unit near
equipment that uses infrared rays may cause operational interference.
• Do not put any object (such as a book) on the remote controller. The buttons of the remote
controller may be pressed by mistake, which drains the batteries.
• Make sure the audio rack doors do not have colored glass. Placing the unit behind such
doors may prevent proper remote controller operation.
• If there is an obstacle between the remote controller and the remote control sensor, the
remote controller will not operate.
12
2
(PR-155X, etc.)
30˚
RC-568S
3
Remote control sensor
Amplifier
30˚
DV-S155X