Onkyo 29344937 Instruction Manual page 20

Connecting the AV receiver—Continued
Connecting the Speaker Cables
Terminal posts
1
Strip 1/2"-5/8" (12-
15 mm) of insulation
from the ends of the
speaker cables. (Supplied
speaker cables are already
stripped.)
2
Unscrew the terminal. Fully insert the bare wire,
making sure that it's touching the threaded shaft
in the center. Screw the terminal tight.
The following illustration shows which speaker should be connected to each pair of terminals for up to 7.1-channel
playback.
If you're using only one surround back speaker, connect it to the power amplifier's left terminals.
Powered
Subwoofer
Notes:
• The speakers are configured by using the "Speaker Settings" on page 44 and "Speaker Setup" on page 68.
• When you connect the front high left and right speakers, preparate it sepalately.
20
1/2"-5/8" (12-15 mm)
Surround
back left
speaker
Brown
Tan
Front high Front high
left speaker right speaker
(Optional) (Optional)
Push terminals
1
Strip 3/8"-1/2"
(10-12 mm) of insulation
from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
Blue
Surround Surround
back right left
speaker speaker
Front left Front right
speaker speaker
White
3/8"-1/2" (10-12 mm)
Surround
right
speaker
Gray
Green
Center
speaker
Red