Displaying Sirius Satellite Radio Information; Positioning The Siriusconnect Home Tuner - Onkyo 29344934 Instruction Manual

Listening to SIRIUS Satellite Radio—Continued
■ Deleting Presets
1 Select the preset that you want to
delete.
See the previous section.
2
While holding down the
AV receiver
[MEMORY] button, press the
[TUNING MODE] button.
The preset is deleted and its number
disappears from the display.
Displaying SIRIUS Satellite Radio
Information
Press the [DISPLAY] button repeatedly to cycle
through the available information.
Channel name
Channel number
& preset number
Category
Artist/Composer
name
Song title
Note:
If the category, artist, or song title is not available,
"- - -" will be displayed instead.
■ SIRIUS Satellite Radio Messages
The following messages may appear while using
SIRIUS Satellite Radio.
ACQUIRING
The SiriusConnect receiver is acquiring the signal or no
signal is present. Make sure the SiriusConnect Home
tuner is connected properly and that there are no
obstacles close by.
ANTENNA ERROR
Make sure the SiriusConnect Home tuner is connected
properly.
Channel number
Preset number
Listening mode
SUB UPDATED
Displayed while your subscription is being updated. No
operations can be performed until this message has
cleared.
UPDATING XXX%
Displayed while the channel map is being updated. Wait
until the updating is complete.
SIRIUS UPDATING
Displayed while the SiriusConnect receiver's firmware
is being updated.
INVALID CHANNEL
Displayed if you select an unavailable channel.
CALL SIRIUS
Displayed when you select a channel to which you are
not subscribed. Call SIRIUS if you want to subscribe.
CHECK SR TUNER
Displayed if the SiriusConnect receiver is not connected.
Make sure the SiriusConnect receiver is connected
properly, and make sure its AC adapter is plugged in.
RECEIVER
ENTER
/ / /
SETUP
Positioning the SiriusConnect Home
Tuner
You can check the signal strength of the SIRIUS Satellite
Radio signal and adjust the position of the SiriusConnect
Home antenna accordingly.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
57