Connecting Speaker Set A; Connecting Speaker Set B - Onkyo 29344934 Instruction Manual

Connecting the AV receiver—Continued

Connecting Speaker Set A

1
Strip 1/2"-5/8" (12-15
mm) of insulation from the
ends of the speaker cables.
(Supplied speaker cables
are already stripped.)
2 Unscrew the terminal. Fully insert the bare wire,
making sure that it's touching the threaded shaft
in the center. Screw the terminal tight.
The following illustration shows which speaker should be
connected to each pair of terminals.
If you're using only one surround back speaker, connect it
to the left (L) SURR BACK SPEAKERS terminals.
Front right
speaker
Speaker Set B
20
1/2"-5/8"(12-15mm)
Front left
Powered
speaker
subwoofer

Connecting Speaker Set B

1
Strip 3/8"-1/2" (10-12
mm) of insulation from the
ends of the speaker cables,
and twist the bare wires
tightly, as shown.
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
Note:
While speaker set B is on, speaker set A is reduced to
5.1-channel playback.
Speaker Set A
Front right
speaker
Surround Surround
back right back left
speaker speaker
3/8"-1/2"(10-12mm)
Front left
speaker
Center
speaker
Surround Surround
right left
speaker speaker