Before Using The Dv-Sp303/Dv-Sp303E; Installing The Batteries; Using The Remote Controller - Onkyo DV-SP303 Instruction Manual

Before Using the DV-SP303/DV-SP303E

Installing the Batteries

1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram
inside the battery compartment.
3
Close the battery compartment.
Notes:
• The supplied batteries should last for about six
months, although this will vary with usage.
• If the remote controller doesn't work reliably, try
replacing both batteries.
• Don't mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.

Using the Remote Controller

To use the remote controller, point it at the DV-SP303/
DV-SP303E's remote control sensor, as shown below.
Remote control sensor
STAN DBY/O
N
30˚
30˚
Notes:
• The remote controller may not work reliably if the
DV-SP303/DV-SP303E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the DV-
SP303/DV-SP303E.
• If another remote controller of the same type is used in
the same room, or the DV-SP303/DV-SP303E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
DV-SP303/DV-SP303E is installed in a rack behind
colored glass doors. Keep this in mind when installing
the DV-SP303/DV-SP303E.
• The remote controller will not work if there's an obsta-
cle between it and the DV-SP303/DV-SP303E's
remote control sensor.
DV-SP303/DV-SP303E
OPEN /CLOS
E
PLAY
11