APRILIA CAPONORD Manual page 44

If the system is deactivated, the ABS warning light will stay permanently on.
In both cases, to confirm the selected mode, hold button "B" pressed for a few sec-
onds.
The function will automatically appear after 5 seconds, if the selection is not made
promptly, or when the motorcycle is running.
NOTE
AT KEY ON, IF THE SYSTEM IS FUNCTIONING CORRECTLY, THE ABS INDICA-
TOR LIGHT WILL BLINK (ONCE A VEHICLE SPEED OF 5 Km/h - 3.1 mph IS
02_36
EXCEEDED, THE SYSTEM WILL ONLY BE ACTIVE IF THE WARNING LIGHT
GOES OFF)
NOTE
WHEN THE BIKE'S PANEL IS OFF AND WHEN TURNING IT ON THE NEXT TIME
THE ABS SYSTEM IS STILL ACTIVE, REGARDLESS OF WHAT WAS SET PRE-
VIOUSLY.
CALIBRATION
To access the CALIBRATION function, simultaneously hold buttons "A" and "B"
pressed for a few seconds.
When the function is activated (with vehicle at a standstill), the following wording will
appear on the screen page of the display:
CAL
The high beam light will start to blink fast.
02_37 To calibrate the ATC (Aprilia Traction Control) system, ride for approximately 10 sec-
onds in a straight line on a flat section of road in second gear and at a speed of 30 +/-
2 Km/h (18.64 +/- 1.24 mph), until the message CAL is no longer shown on the display
and the light turns off.
44