Before Using The Cd Receiver; Installing The Batteries; Using The Remote Controller - Onkyo CR-325 Instruction Manual

Before Using the CD receiver

In general, the illustrations in this Instruction Manual show the CR-325.

Installing the Batteries

1 Detach the battery cover by pressing the
tab and pulling up the cover.
2 Insert two batteries (R6/AA) into the bat-
tery compartment.
Carefully follow the polarity diagram (positive
(+) and negative (–) symbols) inside the battery
compartment.
3
After the batteries are installed and
seated correctly, attach the compartment
cover.
Notes:
• If the remote controller doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.
6

Using the Remote Controller

When you operate the remote controller, point it at the
CD receiver's remote control sensor, as shown below.
Remote control sensor
Notes:
• The remote controller may not work reliably if the CD
receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used in
the same room, or the CD receiver is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the CD
receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there's an
obstacle between it and the CD receiver's remote con-
trol sensor.
CD receiver