Fully Fold The Frame Yet - Pro-Form PFTL496140 User Manual

2. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its left side. Partially fold the Frame
(55) so that the treadmill is more stable; do not

fully fold the Frame yet.

If there is a shipping tie securing the Upright Wire
(87) to the Base (95), cut the shipping tie. Then,
locate a plastic tie in the indicated hole in the
Base, and use the tie to pull the Upright Wire out
of the hole.
Attach two Base Feet (90) to the Base (95) in the
locations shown with two #8 x 1" Tek Screws (5)
and two Base Foot Spacers (94).
Then, attach the other two Base Feet (90) with
two #8 x 1" Tek Screws (5).
3. See the inset drawing. Cut the plastic tie near
the Upright Wire (87).
Attach a Wheel (96) to the Base (95) with a 3/8"
x 2" Bolt (8) and a 3/8" Nut (10). Do not over-
tighten the Nut; the Wheel must turn freely.
Then, press a Base Cap (89) into the Base (95).
2
94
90
55
94
3
Plastic Tie
8
96
10
10
Hole
87
5
90
5
87
95
Cut
87
90
5
95
90
5
89