One for All URC-6532 User Manual page 7

Important notes:
- To set up your Video Recorder, Satellite Receiver or Cable Converter,
follow the same instructions above, only press the VCR or SAT key
during step 2.
- Some codes are quite similar. If your device does not respond or is not
functioning properly with one of the codes, follow steps 1-6 with each
code listed for your brand.
- If none of the codes listed for your brand operate your device, follow
the Search Method described in the next section. The Search Method can
be used even if your brand is not listed at all.
- Remember, to control your device after you have programmed it with
the ZAPPER, you must press the device key first (TV, VCR or SAT).
TV Code
VCR Code
SAT/Cable Code
Volume - = 2
(Example: To enter the Sony TV code 24432, you would press Volume(-),
Programme(-), Programme(-), Programme(+), Volume(-).
If your device does not respond to the ZAPPER after you have tried all
the codes listed for your brand, try the Search Method.
Make sure you write your correct 5 digit codes in the boxes
provided inside the battery compartment and on this page.
WWW.ONEFORALL.COM
Programme + = 3
Programme - = 4
Volume + = 1
7