Table of Contents
Advertisement
FIGURE B
3.
Firmly secure the Clamp Ring (1) to
the Angle Grinder's Mounting Plate by
tightening the two phillips Screws (2) on
the Clamp Ring. (See figure B.)
note: The Safety Guard comes with an
Inner Flange (3) if your Angle Grinder
brand/model requires an Inner Flange to
properly attach the Safety Guard.
figure c
INNER FLANGE (3)
(IF APPLICABLE)
OUTER FLANGE
4.
If your Angle Grinder requires the use
of an Inner Flange (3) insert the Inner
Flange, Blade/Disc, and wrench tighten
the Outer Flange onto the Shaft of the
Angle Grinder. (See figure c.)
note:
5.
If your Air Grinder does not
require the use of an Inner Flange, insert
only the Blade/Disc, and wrench tighten
the Outer Flange onto the Shaft.
SKU 45921
SCREW (2)
CLAMP
RING (1)
SCREW (2)
CLAMP
RING (1)
BLADE/DISC
for technical questions, please call 1-800-444-3353.
figure d
6.
Attach the Guide Surface (4) to the
Safety Guard, using the two Washers (5)
and two Wing Nuts (6). (See figure d.)
7.
note:
The depth at which the Blade/
Disc cuts may be adjusted by loosening
the two Wing Nuts (6), sliding the Guide
Surface (4) in or out and, then, tightening
the two Wing Nuts. (See figure d.)
operAtion
follow operation instructions and
safety warnings in the manual for the
Angle grinder used.
GUIDE SURFACE (4)
WASHER (5)
WING NUT (6)
Page 5
Advertisement
Table of Contents
