Table of Contents
Advertisement
16.
This product is not a toy. Do not allow
children to play with or near this item.
17.
Use as intended only.
18.
Inspect before every use; do not use if
parts are loose, damaged, or if guard is
not properly secured to the angle grinder.
19.
Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
SAVe theSe
inStructionS.
SpecificAtionS
Angle Grinder
Fits most Angle Grinders With
Compatibility
4" to 4-1/2" Dia. x 1/8" Thick
Discs / Blades
Overall Dim.
2-1/2" W x 6" L x 3-3/4" H
Guide Surface Dim. 2-1/4" W x 6" L
Clamp Ring Dia.
1-9/16"
Construction
Steel
Weight
1.05 lb.
unpAcking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
Page 4
for technical questions, please call 1-800-444-3353.
inStAllAtion
read the entire iMportAnt
SAfety inforMAtion
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
froM AccidentAl
operAtion:
turn the power Switch of the tool
off and unplug the angle grinder
from its electrical outlet before
installing or making any
adjustments to the guard.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
FIGURE A
INNER FLANGE (3)
(IF APPLICABLE)
OUTER FLANGE
1.
Depress and hold the Angle Grinder's
Spindle Lock Pin to prevent the Blade/
Disc from turning. (See figure A.)
2.
Unscrew and remove the Angle Grinder's
Outer Flange, Blade/Disc, and Inner
Flange. (See figure A.)
note: Depending on the brand/model of
your Angle Grinder, there may or may
not be an Inner Flange.
to preVent
SeriouS injury
SPINDLE LOCK PIN
MOUNTING
PLATE
SHAFT
BLADE/DISC
SKU 45921
Advertisement
Table of Contents
