Toro 07205 Operator's Manual page 31

GREASING BEARINGS AND
BUSHINGS
WARNING
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake and
remove key from the ignition switch. Any load
material must be removed from bed or other attach-
ment before working under raised bed. Never
work under a raised bed without positioning safety
support on a fully installed cylinder rod. Always
rotate the safety support to the down position
before working under the raised bed.
The vehicle has (18) grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings and
bushings after every 100 hours of operation. More
frequent lubrication is required if used for heavy
duty vehicle operations.
The grease fitting locations and quantities are: Tie
rod ends (4) (Fig. 16); Front ball joints (4) (Fig. 16);
Rear drive shafts (6) (Fig. 17); Front pivot bushings
(2) (Fig. 18); Mid drive shaft—4 Wheel drive only
(3) (Fig. 19); Pedal Pivots (4) (Fig. 20); Steering
shaft (1) (Fig. 21) and Accelerator Arm (1) (Fig. 22).
IMPORTANT: When greasing drive shaft univer-
sal shaft bearing crosses, pump grease until it
comes out of all 4 cups at each cross.
1. Wipe the grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Maintenance
Figure 16
Figure 17
Figure 18
31