Setup; Installing The Handle - Toro 22295 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2
Hex-head-flange bolt (5/16 x 1-1/2 inches)
2 Carriage bolt (5/16 x 1-1/2 inches)
4 Flange nut (5/16 inch)
Procedure
1. Remove the 2 cable guards from the handle (Figure 3)
by removing the 2 carriage bolts and 2 locknuts that
hold each cable guard to the handle.
Description
Handle
Hex-head-flange bolt (5/16 x 1-1/2
inches)
Carriage bolt (5/16 x 1-1/2 inches)
Flange nut (5/16 inch)
No parts required
No parts required
No parts required
Qty.
1
2
Install the handle.
2
4
–
Install the starter rope.
–
Fill the crankcase with oil.
–
Adjust the self-propel drive.
1. Cable guard
2. Locknut (4)
3. Carriage bolt—1/4 x 1-1/2
inches (4)
Note: Save the guards, carriage bolts, and locknuts
so that you can install them onto the handle later in
this procedure.
2. Install the handle ends onto the mower housing with
2 hex-head-flange bolts (5/16 x 1-1/2 inches) and 2
flange nuts (5/16 inch) as shown in Figure 3.
3. Set the machine to the desired cutting height; refer to
Adjusting the Cutting Height (page 11).
7
Use
Figure 3
4. Flange nut—5/16 inch (2)
5. Hex-head-flange
bolt—5/16 x 1-1/2 inches
(2)